Inbox Inspiration

Subscribe to the PLAID Crafts Newsletter,
and we’ll throw in $10 towards your next purchase.

Mod Podge Tricks and Treats Halloween Necklace

Create Halloween jewelry with Mod Podge pendant trays, seed beads and Dimensional Magic.

This project features these great brands:

  • Mod Podge Finishes and Formulas Logo
  • Mod Podge Tools and Accessories  Logo
supplies

Mod Podge ® Podgeable Metal Pendant, Oxidized Brass

Number Needed: 1 $0.00 $3.29
Item available exclusively at Walmart

Mod Podge ® Gloss, 8 oz.

Number Needed: 1 $0.00 $7.29
Item available exclusively at Walmart

Mod Podge ® Dimensional Magic, 2 oz.

Number Needed: 1 $0.00 $6.29
Item available exclusively at Walmart
instructions

Other Supplies

Halloween Papers, Pencil, Scissors, Small flat paintbrush, Rhinestones, Orange Seed Beads, Beading Wire, Jump-ring, Clasp, Crimp Beads, Jewelry Pliers, 6 large Purple Beads, 4 Medium Clear Beads, 32 Small Black Beads, 14 Medium Black Beads

Instructions

  1. Begin with a rectangle Pendant Tray. Choose your background paper. Trim the paper to fit inside the pendant tray. Use layers of paper if desired.
  2. Apply a thin coat of Mod Podge to the pendant tray and to the back of the background paper. Position the background paper in the tray. Smooth with your fingers. Apply a top-coat of Mod Podge.
  3. Using Mod Podge as a glue, attach a seed beads and few gems to the design. Allow to dry for 2 hours.
  4. Fill in the pendant with Dimensional Magic. Begin around the outer edge and fill until the entire pendant is covered. Dry for 24 hours in an undisturbed and non-drafty place.
  5. Create the necklace by first laying out all your beads. Begin by attaching one end of the clasp to beading wire using a crimpbead.
  6. Using the photo as a guide, thread the beads onto the wire. Begin on one side and work your way to the center. Thread your pendant onto the wire and continue beading using the photo as a guide. Attach a clasp to the end and trim the end of the wire. Tuck the ends of the wire through the beads.

Tip: While the Dimensional Magic is drying don’t move the pendant around or you might get air bubbles. If you do get an air bubble, use a sewing pin to pop it.

Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.