Mod Podge ® Roller Tops with Bottle

Decorated candles using Mod Podge ® or Royal Coat ® Decoupage Finish are meant for decorative purposes and not for illumination. Many of the decorations would catch fire and be hazardous if the candle were burned. However, if you are using a wide pillar candle and the decorations do not go to the top of the candle, it can be burned down slightly to create a well, then a votive candle inserted into the well. A new votive candle can be inserted when the old one is finished. Use extreme caution and good judgment when burning candles that have been decorated.

First check to see if the napkin is 2 ply. If so, separate and lay aside. Brush Mod Podge directly on the your surface. Carefully place the printed napkin on the surface and lightly blot down with a dampened sponge. Start blotting in the center and work to the edge. Once it is in place, let dry. After about 30 minutes lightly apply a top coat of Mod Podge.

1. Apply a coat of Mod Podge® to the inside of the form and allow to dry slightly. Place the Napkin design where desired and gently rub it flat with your thumb.
2. Cover the image with a second very thin coat of Mod Podge®, beginning in the center and brushing out. Allow to dry thoroughly.
3. Add special sponging or spouncing effects, as desired, around the design and let dry.
4. Paint the whole inside with a light color of FolkArt® Acrylic Colors. If you want to use a darker color inside, first paint around the Napkin design with a light color, let dry and then add the darker color.

1. Cut the design out of the Napkin and separate the layers.; you want to use only the top layer of the Napkin.
   
   
2. Using the Glue Brush, apply a coat of Mod Podge® Gloss, Matte or Sparkle Finish to the surface area where the Napkin will be applied. Let dry slightly – until it’s slightly sticky – then place the Napkin on the surface and press it down gently with your fingertips. The Napkin should not become wet. (If it does, you applied too much Mod Podge; apply a lighter coat next time.) Let dry.
   
   
3. To finish, apply a second coat of Mod Podge® and apply it beginning in the middle and gently brushing out to the edges.
   
   
4. Alternately, you may apply Mod Podge® to the area and let it dry completely (to speed up drying, you may use a hairdryer set on low). Then place the Napkin onto the surface in the desired position. Cover the Napkin with a piece of parchment paper and iron (on the cotton setting) to adhere the Napkin to the surface. Allow the parchment paper to cool and then remove. The Mod Podge® will melt and adhere the image to the surface. The advantage of this technique is that you can move the image until you iron it down. Also, the Napkin will not tear or show bubbles, and it will be completely flat like the surface it is on. Again, finish with a coat of Mod Podge® on top.

There are two different ways to prepare your napkin or paper for appliqué, depending on what look you wish to create:

Cutting:
Use small, sharp scissors for cutting out the napkin or paper designs. Cut away any inside areas you don’t want. Hold the scissors stationary while turning the napkin or paper for a clean-edge cut. Trimming is easier when you cut through all three layers of the napkin or paper. Remove the two white layers after cutting out the design.

Tearing: Tearing can be a good choice for some designs because is creates a more handmade or natural look. It’s perfect for children and others who cannot or do not want to cut out the designs. For best results, cut all three layers and then separate.