#1 Liner brush
1/2" Stencil brush
Stencil tape or stencil adhesive
1” Foam applicator
surface Wicker White using 1” foam applicator; allow to dry. Sand rough areas using sandpaper. Reapply basecoat.
dry, position stencil; either tape in place or use stencil adhesive.
brush into Mushroom; wipe onto paper towel to remove excess.
stenciling in a circular motion.
stencil, reposition and repeat until design area has been stenciled.
up with mild soap and water.
needed, clean up “over stenciled” areas with #1 liner brush and Wicker
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.
Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.
Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.