Leather Studio™ Decorator Brush Set
Upcycle flea market and thrift store finds into new fashion statements. Decorate any leather and vinyl surface, such as shoes, belts and bags. Use the Decorator Brush Set for creating fine lines, brush strokes, and decorative purposes.
Black soft leather trim piece
1” stencil tape
Cut 1” squares from stencil tape. Turn them to make diamonds. Line up the diamonds point to point so they are going across the length of the cuff. Make three rows across leaving about 3/8” open in between. One may come off of the top or bottom of the cuff.
Paint 3/8” zigzags Sunflower, Red and then a half diamond orange. Refer to photo for reference.
Remove the tape and paint in the black openings with Amethyst. Allow to dry.
Paint the line design on the Amethyst with Magenta.
Outline the the squares and triangles with Aqua. Allow to dry.
Make dots in Magenta and Sunflower.
Make a clasp by cutting two slits through both ends. Cut a 2” dowel piece with craft knife and slide through both holes
Project Tip: Instead of using the dowel you can you snaps that are made for leather.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.
Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.
Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.