Leather Studio™ Decorator Brush Set
Upcycle flea market and thrift store finds into new fashion statements. Decorate any leather and vinyl surface, such as shoes, belts and bags. Use the Decorator Brush Set for creating fine lines, brush strokes, and decorative purposes.
Tape off a large section of the front of boot. Basecoat with Parchment. Allow to dry completely.
Measure the distance between the top of the color block to the bottom. This is will be the length of the diamond pattern. Measure the shoe across the front, from side to side, to determine the width of the diamond. Once the size is determined draw it onto a scrap piece of paper. This will be the pattern for the diamond.
Place the paper diamond pattern onto the front of the shoe. Secure with tape if necessary. Tape of each side of the diamond.
Cut down 1/8” strips of tape to go across the taped off diamonds crossing in the middle of diamond.
Paint the diamond with ½” angled brush in Grey. Allow to dry. Remove tape.
Paint Orange stitching with the liner brush where the 1/8” tape crossed over inside the diamond.
Use the pattern again to follow the diamond shape which also makes a diamond with the stitching.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.
Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.
Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.