I Want To Create For
Crafting for Occasions
0 items
Shopping Cart

Halloween Plate and Charger

By: Cathie & Steve
Cathie & Steve
Cathie & Steve
Cathie Filian and Steve Piacenza are handcraft designers, Emmy Nominated television hosts, book authors, lifestyle experts and the inventors of Hot Glue Gun Helpers. Their shows can be seen in the United States, Australia, South Africa, The Philippines and on the Armed Forces Network.  They were nominated for two Daytime Emmys. Cathie and Steve has also appeared on numerous network shows and specials for NBC, ABC, Discovery Channel, HGTV, DIY and Food Network.  Programs such as Rachael Ray, IVillage Live, View From the Bay and the Florence Henderson Show have featured their creative ideas.
A vintage inspired plate and charger for Halloween.
not yet rated   AT A GLANCE
Skill Level: Beginner


FolkArt ® Metallics - Silver Anniversary, 2 oz.
Item #506
Premium, all-purpose shimmering metallic acrylic paint for decorative crafts and home décor. Superior coverage. Exceptional brushability. Use on all porous surfaces. All colors are certified AP non-toxic, water-based, and acid neutral.


Mod Podge ® Gloss, 16 oz.
Item #CS11202
Mod Podge ® is quick-drying for multiple coat build up and dries clear. Can be sanded to a smooth finish. Cleans up easily while wet with soap and water. Certified AP non-toxic; waterbase. Mod Podge ® is an all in one decoupage glue, sealer and finish.


Other Supplies
Black plate charger
Paper towel
Torn book pages
Foam paintbrush
Glass plate
Halloween themed scrapbook paper


  1. Dampen and scrunch the paper towel into a ball.  Dip the ball into the silver paint and tap off the excess paint.  Tap the paper towel around the edge of the charger.
  2. Tear the book pages into squares.  Size them to fit around the inside base of the charger.  Coat the back of each one with Mod Podge, position onto the charger, smooth any air bubbles with your finger and top coat with a layer of Mod Podge.  Continue adding more pieces until the entire center is filled. Allow to Dry.
  3. Using the plate as a guide, cut a circle from Halloween scrapbook paper to fit the base of the glass plate. Coat the printed side of the circle with Mod Podge, position onto the center back of the plate, add a layer of Mod Podge to the back side of the paper, smooth any air bubbles with your finger and top coat with a layer of Mod Podge. Wipe around the edge of the paper with a damp paper towel to clean the edges. Allow to Dry.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.