I Want To Create For
Crafting for Occasions
0 items
Shopping Cart

Floral Edged Mirror with Mod Podge

By: Amy Anderson
Amy Anderson
Amy Anderson
I am a 32-year-old transplant from Seattle living in Atlanta, Georgia. I was born from creative genes, so I'm carrying on the tradition. I have been knitting for 17 years, sewing for longer and decoupaging for just a few. I do all of these things on a daily basis, or at least as much as I can. Follow my crafting adventures on the ModPodgeRocks blog.
This plain, budget friendly mirror was given a new life with the help of some bright and fun fabric.
not yet rated   AT A GLANCE
Skill Level: Intermediate


Mod Podge ® Matte, 8 oz.
Item #CS11301
Mod Podge ® is quick-drying for multiple coat build up and dries clear. Can be sanded to a smooth finish. Cleans up easily while wet with soap and water. Certified AP non-toxic; waterbase. Mod Podge ® is an all in one decoupage glue, sealer and finish.


Other Supplies
Mirror with a flat edge - you’ll need the edge to be at least 2” wide
Fabric of your choice – I used a body pillow cover
Craft knife and mat
Paintbrush.Medium grit sandpaper and tack cloth (optional).Wax paper (optional).Waterproof sealer (optional)


  1. Prepare the fabric by washing and drying. Cut the pillow cover so that it is one single layer of fabric (as opposed to double thickness) and place on a non-stick surface (wax paper is recommended).
  2. Sand the edge of your mirror (if required) and wipe away dust with the tack cloth.
  3. Measure the edge of your mirror (mine was 2”). You’ll need to cut four fabric strips, one for each side of the mirror, to fit. I did this by using a ruler and marking with a pen on the BACK of the fabric. Then I cut the fabric using the ruler, craft knife and mat.
  4. At each corner, cut at a perfect 45 degree angle using your craft knife and mat. Make sure that these fit the mirror before trimming.
  5. Start on one side, and Mod Podge down the fabric. Add a medium layer of Mod Podge to the mirror edge surface, place the fabric down and smooth. Let dry for 15 – 20 minutes and repeat. Work your way around the mirror until all four sides are covered. Let dry.
  6. At this point you can trim the fabric to fit the mirror OR fold the fabric over the sides.
  7. Give all four sides a top coat of Mod Podge and let dry. Repeat and let dry.
  8. Scrape any excess Mod Podge that got onto the mirror off with a razor blade before hanging.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.