I Want To Create For
Crafting for Occasions
0 items
Shopping Cart

Faux Bone Inlay Dresser

By: Cathie & Steve
Cathie & Steve
Cathie & Steve
Cathie Filian and Steve Piacenza are handcraft designers, Emmy Nominated television hosts, book authors, lifestyle experts and the inventors of Hot Glue Gun Helpers. Their shows can be seen in the United States, Australia, South Africa, The Philippines and on the Armed Forces Network.  They were nominated for two Daytime Emmys. Cathie and Steve has also appeared on numerous network shows and specials for NBC, ABC, Discovery Channel, HGTV, DIY and Food Network.  Programs such as Rachael Ray, IVillage Live, View From the Bay and the Florence Henderson Show have featured their creative ideas.
Create a faux bone inlay look with FolkArt Multi Surface Paints and stencils.
not yet rated   AT A GLANCE
 
Skill Level: Intermediate
Time:
THIS PROJECT FEATURES THESE GREAT BRANDS:
INSTRUCTIONS & SUPPLIESREVIEWS

Supplies

Other Supplies
Dresser
Sandpaper
Wipe-cloth
Foam bowl
Stencil tape
ArtMinds stencil #478855

Instructions

  1. Remove any drawer pulls. For non raw wood furniture: Lightly sand the surface of the furniture and wipe clean. Paint one (1) solid coat of Milk Paint Bonding Primer and Sealer on the dresser. Use long brush-strokes. Allow to dry.
    • TIP: If you are using raw wood furniture, you do not need to prime the dresser.
  2. Using long brushstrokes, paint the first cost of Brass Buckle on the dresser. Allow to dry for approximately two (2) hours. Lightly sand in the direction of the grain. Add a second coat of paint and allow to dry.
  3. Determine a design plan with the stencils. Tape in place. Begin with Vintage White and Top with White Pearl. Load the stencil brush with Vintage White, tap off the excess paint. Tap and swirl the brush over the stencil. While wet, stencil White Pearl over the Vintage White. Use short taps to create a random pattern. Lift the stencil and allow to dry.
  4. Continue to stencil a design. Be mindful that you will have dry time in between stenciling for some areas. Clean your stencils as needed during the stenciling process.
  5. Top-coat with a layer of the Bonding Primer and Sealer. Use long brushstrokes. Replace any drawer pulls.
  • TIP: Clean stencils by soaking them in a sudsy bath and gently rubbing any paint from the edges. Dry on a layer of paper towels.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.