I Want To Create For
Crafting for Occasions
0 items
Shopping Cart

DIY Christmas Garland

This metallic DIY Christmas garland will look beautiful in your home this holiday.
not yet rated   AT A GLANCE
 
Skill Level: Beginner
Time:
THIS PROJECT FEATURES THESE GREAT BRANDS:
INSTRUCTIONS & SUPPLIESREVIEWS

Supplies

Delta Ceramcoat ® Acrylic Paint - Metallic 14K Gold, 2 oz.
Item #026040202W
All-purpose high quality acrylic paint formulated for the decorative painter and craft enthusiast. Excellent coverage on all porous surfaces. Waterbased and Non-Toxic.

$2.49

This item is currently
out of stock
Delta Ceramcoat ® Acrylic Paint - Metallic Copper, 2 oz.
Item #026070202W
All-purpose high quality acrylic paint formulated for the decorative painter and craft enthusiast. Excellent coverage on all porous surfaces. Waterbased and Non-Toxic.

$2.49

Other Supplies
Four Sheets of black poster board (not coated)
6" Leaf template cut from cardstock
Small pinecone
Ribbon the length you desire your garland to be
Foam roller
1" flat brush
Pencil
Scissors
Craft knife
Ruler
Water basin
Paper towels
Foam plate

Instructions

  1. Paint two of the poster boards with the foam roller Metallic Gold, and one sheet in the Metallic Copper. Paint two coats on each side of the poster boards. Let dry.
  2. Paint pinecone in Metallic Gold and set aside.
  3. Trace leaf shape on one side of the poster boards spacing as tight as possible. Cut out the leaves. Lightly score each leaf from point to point using a craft knife and ruler.
  4. Gently fold each leaf away from the scored line.
  5. Set aside 6 Gold leaves for the centerpiece. Divide the remaining number of leaves in half.
  6. Fold the ribbon and mark the center. Starting at one end, Mod Melt attach each leaf to the ribbon. Attach in sets of three. Occasionally adding a Copper leaf. Stop 4 inches from the center.
  7. Flip the ribbon over and repeat the process on the other half of the ribbon.
  8. To create the centerpiece, cut a 2" round circle from the poster board scrap.
  9. Glue the 6 leaves onto the circle by each leaf's point. Glue the pinecone in the center.
  10. Finally glue the centerpiece into place. Glue a small ribbon loop to the back of the centerpiece for hanging. Tie two additional loops to the main ribbon approximately 12" from the end.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.