I Want To Create For
Crafting for Occasions
0 items
Shopping Cart

Decoupaged Decorative Planter

  (1)   AT A GLANCE
 
Skill Level: Beginner
Time:
THIS PROJECT FEATURES THESE GREAT BRANDS:
INSTRUCTIONS & SUPPLIESREVIEWS

Supplies

FolkArt ® Outdoor™ Acrylic Colors - Burnt Umber, 2 oz.
Item #1618
Rich and creamy premium quality acrylic paint formula formulated for use outdoors. UV and weather resistant, FolkArt Outdoor is self-sealing and dries to a satin sheen. Paint on a variety of surfaces, including: unpainted or painted metal, tin, terra cotta, wood, stone and concrete. Use for traditional stroke work, stenciling or sponging, colors blend like regular FolkArt acrylic paints. Cures in 48 hours.

$2.59

FolkArt ® Outdoor™ Acrylic Colors - Light Blue, 2 oz.
Item #1633
Rich and creamy premium quality acrylic paint formula formulated for use outdoors. UV and weather resistant, FolkArt Outdoor is self-sealing and dries to a satin sheen. Paint on a variety of surfaces, including: unpainted or painted metal, tin, terra cotta, wood, stone and concrete. Use for traditional stroke work, stenciling or sponging, colors blend like regular FolkArt acrylic paints. Cures in 48 hours.

$2.59

Mod Podge ® Matte, 8 oz.
Item #CS11301
Mod Podge ® is quick-drying for multiple coat build up and dries clear. Can be sanded to a smooth finish. Cleans up easily while wet with soap and water. Certified AP non-toxic; waterbase. Mod Podge ® is an all in one decoupage glue, sealer and finish.

$7.29

Other Supplies
Tin planter
Coordinating papers of your choice
Scissors
Tracing paper
Pencil
Foam brush
Fine sandpaper

Instructions

  1. Basecoat inside and bottom of planter Burnt Umber and feet Light Blue. Let dry completely.
  2. Using tracing paper, make a pattern piece for front/back and sides of the top ¾ of the planter (we suggest making these slightly larger).
  3. Following pattern pieces, cut a front, back and two sides from flower paper. Using a clean foam brush, apply Mod Podge to back of paper piece then position on planter surface, working slowly to remove air bubbles and wrinkles. Repeat to cover front, back and both sides, trimming paper pieces to meet at edges or slightly overlap. Refer to photo for flower paper placement.
  4. Cut strips of striped paper to fit around bottom ¼ of planter. Repeat technique in step 3 to apply paper to planter.
  5. Cut one large blue flower motif from paper; glue to center of planter as shown.
  6. Apply one coat of Mod Podge over all of paper covered areas.Let dry.
  7. Apply two additional coats of Mod Podge, completely drying between each application.
  8. Thoroughly wet sandpaper under running water then squeeze out slightly. Using light pressure, sand entire decoupaged area of planter. Brush off dust then apply one final coat of Mod Podge. Let dry completely.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.