Two 3.5" blocks
1" x 36" square dowel
Six different patterned scrapbook papers
Laser jet printer
Cut the 1" x 36" square dowel into three 7" pieces.
Trace block onto the back of paper. Cut out the square. Repeat for each side.
Tip: If you want the border of natural wood to show you need to trim off 1/4" from each side.
Mod Podge paper to each side of the blocks.
Using the digital downloads, print out numbers and months of the year.
Cut out the circles and mod podge each as follows: 1st block 0,1,2,3,4,5 2nd block 0,1,2,6,7,8. (Number 6 on this cube will serve also as 9 when needed).
Cut out the months and mod podge to each side of the 7" pieces of wood.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.
Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.
Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.