Apply liquid stencil adhesive to back of stencil referring to bottle for application instructions.
Center stencil on wall and apply Oatmeal with chalk paint brush. Remove stencil and clean if needed.
Place stencil on either side of first chevron and repeat process.
Continue left and right, up and down until wall is covered.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.
Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.
Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.