Insulation in sheet – not the fuzzy kind
Drill or screwdriver
D Rings and wire for hanging
- If necessary, remove glass and old picture from frame
so you have an open frame.
- Paint frame
color of your choice – we chose a Lime Green.
When dry you can sand and distress with 80 grit sandpaper, or if your
frame has a lot of carved detail like this one did, you can just glaze it to highlight the
- Mix one part Extreme Glitter
paint (we chose black) with four parts water and using a very dry brush apply a
little at a time to the frame making sure you don’t drip or splatter. Cut a piece of the insulation to the size of
the frame(this is a wonderful trick
and allows you to inexpensively make any size bulletin board without using
cork). Using spray adhesive, apply the
burlap and trim to size.
- Insert into
frame and attach with wood screws around the back edge. Attach D rings and hanging wire and enjoy!
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.
Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.
Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.