Yes, simply
coat the inside of the pot with a brush-on varnish or sealer.
On most surfaces, FolkArt Home Decor Chalk dries to the touch very quickly. However, 2 hours of dry time is recommended in between coats. Note: a hair dryer may be used to speed up drying time on thin coats of paint (a hair dryer used on a very thick
coat of paint can cause ...
Chalkboard paint, when applied to a variety of surfaces, will create chalkboards. Sticks of chalk can then be used to write on the chalkboards. FolkArt Home Decor Chalk is an acrylic paint that dries within minutes to an ultra matte finish. Due to its thick consistency, this...
If basecoating concrete such as a statue, a lime neutralizer is needed. Household white vinegar works fine.
Coat concrete with vinegar, let dry, rinse well and dry thoroughly before painting. The paint is not recommended for large concrete areas subject to foot traffic suc...
Almost anything can be applied to a project surface when using Mod Podge Ultra, including design elements such as: decorative papers, tissue paper, fabric, magazine cutouts, computer printouts, newspaper, scrapbooking embellishments, copies of photographs, 3D dimensional eleme...
Mod Podge Ultra is best applied to a project surface by evenly spraying the surface while moving the bottle left to right. Work in small sections at a time to fully wet the surface. Immediately place all design elements onto the wet surface. To prevent an excess application an...
For unfinished wood: Apply a base stain or clean wood sealer and allow adequate time to dry. After stenciling, wait 2-3 days and apply waterbase varnish to finish. Test a small section before applying the finish
coat. Choose waterbase finishes; oil-base polyurethane can y...
First, prepare your project surface. Then using the Martha Stewart Crafts Soft Bristle Decoupage Brushes, apply one even, smooth
coat of Martha Stewart Crafts Decoupage Finish of your choice to the surface. Apply one smooth, even application of the Martha Stewart Crafts Dec...
It is best to brush a
coat of Mod Podge Pearl onto the project surface as well as evenly over the back of the paper to be decoupaged. Flip the paper over, place it onto the project surface joining glue to glue, and then press to smooth out any wrinkles or captured air pockets...
A light background works best. If you have a surface that is fairly dark, basecoat it first with your choice of FolkArt Outdoor Acrylics. Cut the design out of the Napkin, separate the layers and discard the two bottom white layers. Using the Glue Brush, apply a
coat of ...