I Want To Create For
Crafting for Occasions

Woodland Charm Bracelet

By: Chris Myer Williams
Chris Myer Williams
Chris Myer Williams
I have always found comfort and happiness when I was busy designing and creating. I have many interests and talents and often I am torn when deciding which art medium to work creatively in. Decorative painting is my first love; however, I also enjoy stenciling, jewelry making, sewing, crochet, needlework of all kinds, cooking, card making, faux finishes, decorating and gardening. Working in the craft and hobby industry for many years, I have enjoyed the pleasures of traveling, teaching, and sharing with others basic crafting how-tos! Currently, I am employed as the Marketing Education Director at Plaid. My career journey to this day, is still allowing me the gift of sharing with others the joys of crafting and finding their creative spirits! I hope that our creative paths may cross one day. Until then... happy creating!
It is fun to dress for the seasons and why not include your jewelry accessories too?
not yet rated   AT A GLANCE
Skill Level: Intermediate


PLAID Supplies
  • Martha Stewart Crafts ® Jewelry Tools - Small Flush Cutter
  • Martha Stewart Crafts ® Jewelry Tools - Round Nose Pliers
  • Martha Stewart Crafts ® Jewelry Tools - Chain Nose Pliers
  • Martha Stewart Crafts ® Jewelry Beads - Brown 8mm Faceted Round
  • Martha Stewart Crafts ® Jewelry Chains - Fat Oval Gold
  • Martha Stewart Crafts ® Jewelry Findings - Jump Rings Twist Gold
  • Martha Stewart Crafts ® Jewelry Findings - Toggle Clasps Leaves
  • Martha Stewart Crafts ® Jewelry Enamel Blanks - Owl
  • Martha Stewart Crafts ® Jewelry Pendant - Acorn Locket
  • Martha Stewart Crafts ® Jewelry Enamel Blanks - Mushroom Set
  • Martha Stewart Crafts ® Jewelry Charms - Ladybug
  • Martha Stewart Crafts ® Jewelry Charms - Deer
  • Martha Stewart Crafts ® Jewelry Charms - Leaf Variety
  • Martha Stewart Crafts ® Jewelry Charms - Pinecone
  • Martha Stewart Crafts ® Jewelry Charms - Hedgehog
Other Supplies
Gold eye pins
gold head pins


  1. Determine the length of your bracelet. Note: average bracelets measure 7” in length including the toggle clasp. If the closure is a toggle clasp, reduce the chain by approximately 1 inch. After determining desired length of chain, cut using small flush cutters.
  2. Using chain nose pliers and round nose pliers open and close a gold jump ring.
  3. Attach the half of the toggle clasp to one end of the chain using the open jump ring. Close jump ring and repeat for the other end of the chain and clasp. Check length measurement prior to adding your charms.
  4. Create bead charms using either a head pin or an eye pin. Thread the pin with color coordinating Czech beads, some charms will have one bead, others will have two. Make a loop at the top using the round nose pliers and trim excess pin using small flush cutters.
  5. If the bead charm was made as a connector, add a fall-themed charm to one end using a jump ring.
  6. Lay your chain bracelet out and design the placement of each fall-themed charm as well as the bead charms. You may wish to place the largest charm in the center and work the variety of charms out from the center.
  7. Once you are happy with the placement, begin adding the charms to your chain bracelet using jump rings until all charms have been added.
Tip: Adding a bead connector is fun and will “drop” a charm down from the chain so that it can be highlighted rather than be lost in the mix of charms and beads!
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.