I Want To Create For
Crafting for Occasions

Snowflake Podgeable Pin

By: Cathie & Steve
Cathie & Steve
Cathie & Steve
Cathie Filian and Steve Piacenza are handcraft designers, Emmy Nominated television hosts, book authors, lifestyle experts and the inventors of Hot Glue Gun Helpers. Their shows can be seen in the United States, Australia, South Africa, The Philippines and on the Armed Forces Network.  They were nominated for two Daytime Emmys. Cathie and Steve has also appeared on numerous network shows and specials for NBC, ABC, Discovery Channel, HGTV, DIY and Food Network.  Programs such as Rachael Ray, IVillage Live, View From the Bay and the Florence Henderson Show have featured their creative ideas.
Make a holiday themed pin for yourself or as a gift.
not yet rated   AT A GLANCE
 
Skill Level: Beginner
Time:
THIS PROJECT FEATURES THESE GREAT BRANDS:
INSTRUCTIONSREVIEWS

Supplies

PLAID Supplies
  • Mod Podge ® Acrylic Shapes - Basics, Flat & Charm
  • Plaid ® Hot Glue Gun Helpers
  • Mod Podge ® Hard Coat, 8 oz.
Find these items in the Plaid Store!
Click for promotion details
Other Supplies
Mod Podge Holiday Papers or holiday themed scrapbook papers
Mod Podge Podgeable Snowflake or other snowflake shape embellishment
Pencil
Scissors
Foam Paintbrush
Beads
Headpins
Jump-rings
2 Jewelry pliers
Gem glue
Pin backing

Instructions

1. Create the Podgeable pin by placing the holiday shape on holiday themed papers, trace around the shape and cut out the design. (For this design we used one holiday shape and one small circle.)  Apply a coat of Mod Podge to the back of the Podgeable shape and to the top of the paper, sandwich the two together, press with your fingers and allow to dry.  Once dry, trim any excess paper from the edges.  Repeat with the circle shape. 

2.Once they are dry, glue together with the circle in the center.  The loop on the Podgeable shape will be the bottom of the pin.

3. Attach beaded dangles to the loop on the Podgeable shape.  First attach a jumpring to the loop on the Podgeable. Thread a bead onto a headpin, trim the length of the headpin if needed.  Form a loop at the end of the bead and attach to the jumpring.  Repeat with more beads.

4. Using gem glue, attach the pin back to the back of the Podgeable shape so the dangle is facing down.

PROJECT TIP: Mix up the colors by adding beads of different colors and sizes.

Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.

Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.

Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.