 |  |
| ||||||||||
 |
| |||||||||||
 |  |  | |  |
 | | | | |
 |
|
|||||||||||||
|
 Click image for larger view
|
|
 
 1. Position one stencil on the corner of the storage cube (you will use one design for each sides corner). If needed use masking tape to secure the side of the stencil. 2. Squeeze a long thick bead of paint across the top of the stencil. Using your squeegee at a 45 degree angle and even pressure, pull a thin coat of paint down the stencil until the entire design is covered. 3. Peel the stencil to reveal your design. Wash the stencil with cold water. 4. Allow the design to dry for 24 hours. Heat set with an iron, no steam, cotton setting. Use a pressing cloth. Iron for 30 seconds. 
|
|||||||||||
|
||||||||||||||
|
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.
Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product. Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper. |
||||||||||||||
Home
Craft Categories
Brands
Articles
Store Locator
International Locator
About Us
Contact Plaid
Help
Newsletter
Idea Submission
Independent Retailers
Job Opportunities
Craft Links
Link To Us
Privacy Policy
Copyright
Customer Service: E-mail or call our Consumer Advisory Team
at 1-800-842-4197 Mon - Fri. 8am - 5pm EST
©2000 - 2010 Plaid Enterprises, Inc. All rights reserved.