 |
|
 |


Click image for larger view

|
 |

Heart Bracelet and Earrings
Laura Consiglio
|
 This project is not available online. Please check with your retailer for supplies. |



1. Place gems in this order: tear drop, heart, tear drop, heart, tear drop, rectangle, tear drop, heart, tear drop, heart. 2. Thread string through the top holes in each gem (tie a loose knot at the end to hold for the time being). 3. Using second string, thread bottom holes together. 4. Pull ends of top stretchy string together and tie a tight double knot. 5. Repeat with second string. 6. Glue 2 pink gems side by side and allow to dry for 24 hours. NOTE: Do not glue sides with holes together. 7. Thread string through set of holes on one side of the rectangle then back through the other set of holes, the ends of the string should be coming out of the SAME side of the rectangle gem. 8. Thread string through corresponding holes on pink gems. 9. Tie a tight knot on the top of the pink gems. 10. Connect earring wire to clear string. 11. Repeat all steps for second earring.
|

|
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.
Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.
Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.
|
|