 |
|
|
|
|
Penguin Cling
Holli Long
|
|
- Take the pattern design and place it underneath the Leading Blank (the smooth side of the blank should be up).
- Following the pattern lines, lead the design by squeezing Liquid Leading from the bottle onto the Leading Blank. Let dry completely for at least 8 hours.
- Fill in the design with Window Color. The numbers on the pattern correspond to the last three numbers of the Window Color number. Use the combing tool to smooth paint and eliminate bubbles.
- Allow the Window Color to dry completely for at least 8 hours. Peel the design from the Leading Blank and apply to any glass surface.
Note: Clings are not removable when applied to hard plastic surfaces such as Plexiglas. Window Color is not recommended for outdoor use, surfaces that are damp or have frequent condensation, or surfaces whose temperature during application is below 45° F or above 90° F. Do not apply to painted surfaces, appliances, wood, or skin.
|
|
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.
Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.
Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.
|
|
