 |
|
|
Click image for larger view
|
|
Decoupage Mirror Frame
Karen Reif
|
This project is not available online. Please check with your retailer for supplies. |
 |
8x10 Mirror |
|
Anna Griffin Decorative Paper AG024 |
|
Craft Knife and Cutting Mat |
|
Pencil |
- Remove mirror from frame and set aside.
- Trace outline of frame on the back of the decorative paper. Cut paper to fit, leaving about 1 1/2 inches extra to wrap paper around the back of the mirror's frame.
- Use craft knife and straight edge to cut paper. Mitre the corners.
- Use sponge brush to apply Royal Coat Decoupage Finish to the back of the paper. Carefully place paper on frame and use squeegee to press paper into place. Let dry.
- Apply two coats of Royal Coat Decoupage Finish to the entire frame, allowing the finish to dry between coats.
- Replace mirror in frame and hang. It will take approximately two weeks for your project to cure depending on how thick you applied the Royal Coat Decoupage Finish.
|
|
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.
Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.
Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.
|
|
