 |
|
|
Click image for larger view
|
|
Bandit Trick or Treater
|
|
 |
1 yard of Cheesecloth |
|
6 inch styrofoam cone |
|
2 1/2 inch styrofoam ball |
|
1 1/2 inch wooden dowel |
|
plastic covered wire |
|
poster board |
|
8 inch square brown paper bagging |
|
disposable bowl |
|
hot glue gun and sticks |
|
black fun foam |
|
plastic wrap |
- Cover poster board with plastic wrap. Set aside.
- Connect 6" styrofoam cone and 2 1/2" styrofoam ball using 1 1/2" dowel. Cut cheesecloth into three one foot lengths. Cut a 10" piece of wire and push through cone and bend to desired position for arms.
- Cover entire form with plastic wrap. Place on wrapped poster board.
- Soak cheesecloth in Stiffy.
- Drape cheesecloth over figure, one layer at a time.arrange folds as desired and let dry 48-72 hours.
- Enlarge mask pattern 338%; cut mask from fun foam and tie on ghost.
- Enlarge trick or treat bag pattern 338%; cut out bag from brown paper and glue edges. Stencil pumpkin face onto bag and glue bag to pumpkin.
|
|
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, Plaid Enterprises, Inc. disclaims any liability for untoward results.
Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product.
Copyright: All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper.
|
|
