Q: |
|
A: |
Some papers such as gift wrap and magazine cutouts will warp and bubble after applying Mod Podge. To minimize the warping, spray the front and back of these papers with an acrylic sealer such as Mod Podge Acrylic Sealer, and let dry. Be sure to test the sealer first on the paper you want to use before continuing with the project. Apply Mod Podge to the back of the paper or to the project surface and press the paper firmly to the surface, let dry completely. (Do NOT apply a top coat until the paper has dried completely to the surface.) Let it set for about 5 minutes, then recheck your project to see if there are any more bubbles. If there are, press it down again. If the paper still doesn't lay down, take a straight pin to release air under the paper and press smooth. more... |
|
Q: |
|
A: |
Yes, however you need to check to make sure that the ink will not smear. Test a small piece before starting your Mod Podge project. You can also add additional protection, by spraying the front and back of these papers with an acrylic sealer such as Mod Podge Clear Acrylic Spray, and let dry. Be sure to test the sealer first on the paper you want to use before continuing with Mod Podge. |
|
Q: |
|
A: |
There are two different ways to prepare your napkin or paper for appliqué, depending on what look you wish to create:
Cutting:
Use small, sharp scissors for cutting out the napkin or paper designs. Cut away any inside areas you don’t want. Hold the scissors stationary while turning the napkin or paper for a clean-edge cut. Trimming is easier when you cut through all three layers of the napkin or paper. Remove the two white layers after cutting out the design.
Tearing:
Tearing can be a good choice for some designs because is creates a more handmade or natural look. It’s perfect for children and others who cannot or do not want to cut out the designs. For best results, cut all three layers and then separate.
|
|