Q: |
|
A: |
Some papers such as gift wrap and magazine cutouts will warp and bubble after applying Mod Podge. To minimize the warping, spray the front and back of these papers with an acrylic sealer such as Mod Podge Acrylic Sealer, and let dry. Be sure to test the sealer first on the paper you want to use before continuing with the project. Apply Mod Podge to the back of the paper or to the project surface and press the paper firmly to the surface, let dry completely. (Do NOT apply a top coat until the paper has dried completely to the surface.) Let it set for about 5 minutes, then recheck your project to see if there are any more bubbles. If there are, press it down again. If the paper still doesn't lay down, take a straight pin to release air under the paper and press smooth. more... |
|
Q: |
|
A: |
Yes, however you need to check to make sure that the ink will not smear. Test a small piece before starting your Mod Podge project. You can also add additional protection, by spraying the front and back of these papers with an acrylic sealer such as Mod Podge Clear Acrylic Spray, and let dry. Be sure to test the sealer first on the paper you want to use before continuing with Mod Podge. |
|
Q: |
|
A: |
You must pre-wash, dry and iron the fabric. DO NOT use fabric softener. If using a t-shirt or a thin fabric, place a piece of wax paper inside directly under where you will be decoupaging your design. |
|