Martha Stewart Prints Charming Candle Instructions:
- Stencil monogram letters and embellished border trim
Wedding Cake Gloss Opaque.
- Using Martha Stewart Crafts Spray Paint System, paint Mace,
Ballet Slipper, and/or Pink Flamingo on exterior glass vessels prior to
stenciling. If desired, use patterning
tape to create bands of color. Allow spray paint to thoroughly dry prior
glass in warm soapy water to thoroughly clean; rinse well and allow to
- Moisten paper towel with rubbing alcohol and
wipe over cleaned glass to remove any remaining dirt, grease or soap
film. Allow to dry.
- Peel alphabet stencil from backing sheet; set
backing aside and save for future storage.
- Position adhesive stencil on glass surface
where desired; press in place.
- Squeeze a small amount of paint onto foam
- Load the flat bottom edge of the foam pouncer
with glass paint by dabbing into the puddle of paint. Dab a few times more on a clean spot
on the foam plate to ensure you have the entire foam pouncer loaded
- Holding the foam pouncer as you would a pencil,
begin dabbing straight up and down over the opening of the adhesive
stencil. Continue painting until
the entire design area has been completed.
- Set foam pouncer aside in container of water
for cleaning. While paint is
still wet, neatly and carefully lift stencil by peeling away from the
glass surface. NOTE: Be careful not to drag stencil while
removing it as your painted design may be blurred.
adding stenciled designs over glass surface until desired effect is
achieved. NOTE: When repeating a stenciled letter, it
is best to clean the stencil between uses by rinsing in water and
allowing the stencil to dry thoroughly.
- Set completed project aside for 1 hour to
glass surfaces painted with Martha Stewart Crafts Glass Paints should be
cured to increase the paint’s durability on glass or ceramic
surfaces. Follow either the Bake
to Cure Technique or the Air Cure Technique.
Bake to Cure
Technique – Set dry silkscreened
glassware into cool oven. Set oven to
350°F and bake for 30 minutes. Glass
must heat gradually with the oven to avoid breakage. Do NOT place glass in a hot oven. After 30 minutes, turn the oven off. Allow glass to cool completely in
oven. Wait 72 hours before using. NOTE: Glitter Glass Paints should not be baked to
cure; only use air cure technique when painting with glitter paints.
Technique – Air dry completed project
for 21 days before using. NOTE:
Glitter Glass Paints should not be baked to cure; only use air cure
technique when painting with glitter paints.